High speed Steel Taps:Â These are straight flute general purpose taps which can be used for both machine and hand tapping. They are generally the most economical tool for use on production runs, but are best on materials that produce chips, or where the swarf breaks readily. Where deep holes are to be tapped, in materials which produce stringy swarf, other types of taps may be needed, especially for coarse threads. We manufactured these Taps using best quality raw material by implanting advanced machinery & latest technology. STI brand Taps are most accepted in domestic as well as in international market.
SMALL NUT TAPS: PIC.
RANGE:- 1/8" TO 6"ÃÂ, (M4 TO M150)
HAND & SHORT MACHINE TAPS SPECIFICATION CONFORM
TO IS: 6175:PART 2 & 3 : 1992 (MM)
RANGE:- M 4 TO M68 (COARSE PITCH)
RANGE:- M 5 TO M100 (FINE PITCH)
LONG SHANK MACHINE TAPS SPECIFICATION CONFORMÂ Â
TO IS: 6175: PART 4: 1991 (MM)
RANGE:- M 6 TO M68 (COARSE PITCH)
RANGE:- M 6 TO M52 (FINE PITCH)
NUT TAPS SPECIFICATION CONFORM
TO IS: 6175: PART 5: 1991 (MM), BS:949-1969 (Z - 3)
RANGE:- M 4 TO M36 (COARSE PITCH)
RANGE:- 1/8"ÃÂ TO 1.3/8" (COARSE PITCH)
HAND TAPS SPECIFICATION CONFORM
TO BS: 949:PART-2: 1979
RANGE:- 1/8"ÃÂ TO 3" ( THREADS: BSW, BSF, UNC & UNF)
RANGE:- 1/4 " TO 1.370 (THREADS: BSCY)
RANGE:- 1/4ÃÂ" TO 2" (THREADS: B.S.CONDUIT, B.S.B.)
RANGE:- 0 TO 6 (THREADS: B.A.)
HAND TAPS (BSP) PARALLEL FORM; HAND TAPS (BSPT) TAPER FORM
SPECIFICATION CONFORM TO BS:949-1969 (Z - 3)
RANGE:- 1/8"ÃÂ TO 4"